Rank: Member
Groups: Registered
Joined: 6/21/2015(UTC)
Posts: 2
|
Hi,
My GE washer will not agitate. It will fill up with water, do nothing in the agitate cycle, drain, spin, then turn off. It does everything but agitate. When it is in the agitate cycle the motor and belt will spin(in one constant direction, but the agitator don't move. I replaced the motor a few years ago, and the replacement came with a relay and capacitor setup instead of the clutch assembly. Can you please point me in the right direction.
Thanks,
Ron C.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 10/16/2012(UTC)
Posts: 3,806
Was thanked: 7 time(s) in 7 post(s)
|
Can you easily rotate the lower agitator by hand? If so, the agitator coupler is probably stripped out. Pull the agitator, remove the coupler and check for stripped splines up inside the coupler. If you can't easily rotate the lower agitator, then you have a bad transmission.
Eric
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/21/2015(UTC)
Posts: 2
|
thanks Eric.
the coupler is stripped.
Ron
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
