Rank: Member
Groups: Registered
Joined: 3/21/2015(UTC)
Posts: 1
|
There is a problem with starting and getting it to complete a cycle, whether an automatic, or a timed.
After setting the parameters and pushing the start, it does not start, or starts and drops off. If I pull out on the selector switch and nudge it a little it may start, but may only run fior a Little bit and then stop. If I continue nudging the selector switch and pushing or pulling it out a little bit it will start again. It may then complete its cycle, or require some more nudging and pushing.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 10/16/2012(UTC)
Posts: 3,806
Was thanked: 7 time(s) in 7 post(s)
|
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
