Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error
Timer?
Options
Go to last post Go to first unread
Model: 110 20996 992 Brand: Kenmore Age: 5 - 10 years
Previous Topic Next Topic
hoffa28  
#1 Posted : Sunday, September 1, 2013 10:10:03 PM(UTC)
hoffa28

Rank: Member

Groups: Registered
Joined: 9/1/2013(UTC)
Posts: 2
Hello, I started the wash and all seemed fine. Came back after I thought it was done and lifted the lid and was full of water. The dial looks like it ran through all cycles as it was on the off position. No matter what cycle I put it on nothing happens, but the timer just clicks and continues through the cycles. As it gets to rinse you hear it for a split second try to do something and stops and the timer continues on.

Thank you for the help.
Back to top
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com 		 
Back to top  
fairbank56  
#2 Posted : Monday, September 2, 2013 6:43:40 AM(UTC)
fairbank56

Rank: Advanced Member

Groups: Expert
Joined: 10/16/2012(UTC)
Posts: 3,806

Was thanked: 7 time(s) in 7 post(s)
Can't find the wiring diagram for this washer. Open the control panel and provide a clear photo of the wiring diagram which should be either folded up inside the control panel or pasted to the inside of the back panel on the left side inside control panel.

Eric
Back to top
hoffa28  
#3 Posted : Monday, September 2, 2013 12:07:42 PM(UTC)
hoffa28

Rank: Member

Groups: Registered
Joined: 9/1/2013(UTC)
Posts: 2
Is this picture the right one?
hoffa28 attached the following image(s):
image.jpg
Back to top
fairbank56  
#4 Posted : Monday, September 2, 2013 1:08:09 PM(UTC)
fairbank56

Rank: Advanced Member

Groups: Expert
Joined: 10/16/2012(UTC)
Posts: 3,806

Was thanked: 7 time(s) in 7 post(s)
Yes, it's very blurry but that's ok, I found the diagram elsewhere. I would check the connections at the motor. You will need to remove the cabinet. Unplug the motor connector, check for corroded/burnt wires/terminals, also check wires/terminals at the motor overload switch. You may have an open neutral at the motor. This would allow the washer to fill and timer to run but no power to motor.

Eric

Cabinet removal: Cabinet removing Whirlpool direct drive washer - YouTube

Motor overload switch:

UserPostedImage
Back to top
Users browsing this topic
Guest (2)
Similar Topics
Lid switch or timer? (Washer Repair)
by ToledoJD 7/23/2016 3:52:29 PM(UTC)
Where is the defrost timer? (Refrigerator & Freezer Repair)
by dalekbrooks 9/10/2015 7:34:42 AM(UTC)
Gas Dryer NO HEAT/FLAME and possible bad timer? (Dryer Repair)
by noles9399 2/26/2015 10:12:14 PM(UTC)
Whirpool Estate..Bad Timer? (Washer Repair)
by APPLIANCEDUDE1972 9/20/2014 9:11:27 PM(UTC)
GE Dryer - Motor or Timer? (Dryer Repair)
by mwatson2 12/28/2013 1:01:20 PM(UTC)
Bad Timer? (Washer Repair)
by jtvolk 10/11/2013 5:36:23 PM(UTC)
Defrost timer? (Refrigerator & Freezer Repair)
by gunnerferg 10/10/2013 5:46:56 AM(UTC)
Does this have a defrost timer? (Refrigerator & Freezer Repair)
by boylan 11/2/2012 10:11:55 AM(UTC)
Kenmore Elite - motor or timer? Help! (Washer Repair)
by flenn 10/27/2012 5:06:22 PM(UTC)
GE Profile Timer? (Washer Repair)
by rjledoux 9/2/2012 1:41:15 PM(UTC)
How to disable defrost timer? (Refrigerator & Freezer Repair)
by mokhubi 8/13/2012 12:54:23 PM(UTC)
Faulty timer?? (Dryer Repair)
by pullmyfinger 2/20/2012 5:29:52 AM(UTC)
How to replace oven clock/timer? (Oven Repair (including Ranges and Cooktops))
by aec393 12/15/2011 11:46:50 AM(UTC)
Bad timer? (Washer Repair)
by george248 10/31/2011 7:37:23 AM(UTC)
Where is my defrost timer? (Refrigerator & Freezer Repair)
by evan_w 10/20/2011 6:43:57 PM(UTC)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Privacy Policy | Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET