Rank: Member
Groups: Registered
Joined: 12/15/2008(UTC)
Posts: 9
|
Still trying to find the problem, bobski. Have not replaced any parts, yet. The board for this unit costs about $160, so I am going to try denman's new reccomendations (thank you) before replacing. I will respond when I figure it out.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/15/2008(UTC)
Posts: 9
|
Denman,
I believe it is the board.
But, just to confirm before I place the order:
Retested thermistor and moisture sensor and both passed.
This time when I tested the moisture sensor pins on the board, I pulled the board completely out, unplugging all the connections to the board itself. When I performed the tests yesterday, I had just unplugged the machine from the wall, and the appropriate wiring harness on the board.
Yesterday's test results on the 2000k=1.875
Today's test results on the 2000k setting=675
Is that big of a variation possible?
675 would constitute a resistance of <1 m-ohms, correct??
Also, when it rains it pours. On my Whirlpool Duet Washer (GHW9100LW) I have noticed water streaks on the front of the machine under the door. I assume this is the door seal. If so, is installing a new seal easy?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
[COLOR="Blue"]Is that big of a variation possible[/COLOR]?
Has to be you read it so something is causing it.
Although they do not mention it the polarity of the meter leads may make a difference. I would check it both ways re: red lead on one test point and then the black lead on that test point.
[COLOR="Blue"]
675 would constitute a resistance of <1 m-ohms, correct??[/COLOR]
Yes it is less than one meg-ohm.
Perhaps try cleaning this area with ispropyl alcohol available at drug stores or an electronics contacts cleaner (non-residue type) and a toothbrush (be gentle). Do not reconnect till all the solvent has evaporated.
[COLOR="Blue"]Also, when it rains it pours. On my Whirlpool Duet Washer (GHW9100LW)[/COLOR]
I would start a new thread in the Washer Section to get info on this
Also do an advanced search "duet door seal" with the washer secxtion chosen. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
