Rank: Member
Groups: Registered
Joined: 11/25/2013(UTC)
Posts: 1
|
The dual element on my stove will turn on fully but will not turn off and on to maintain the desired temp. It stays on full heat no mater what temp setting that I turn the dial for.
I replaced the elemen and i replaced the switch.
Can this be caused by anything else?
If i made a mistake with the wire replacement--could this cause the problem?
Thanks.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
Here are your parts includes a wiring diagram. Parts for Frigidaire FES367CESB Range - AppliancePartsPros.comHere is a better wiring diagram that also includes a wiring layout. It is the closest I could find to a CESB unit. It is for a CESC. The only difference I can see is the placement of the Hot Surface light. The circuit is the same they just place it to left of the limiter instead of the right. CESB is L2 , LIMITER , HOT SURFACE light , L1 CESC is L2 , HOT SURFACE light , LIMITER , L1 Yes mis-wiring can cause your problem. The wiring layout may help you figure out the proper wiring. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
