Rank: Member
Groups: Registered
Joined: 4/23/2011(UTC)
Posts: 1
|
The washer will progress through the normal cycle, fill and drain but will not agitate or spin. Approximately 2 months ago I replaced the control board because the washer would not spin. After replacement of the board it worked great for approximately one months; and now the motor will not operate. The belt and motor have less than 50 operating hours.
Thanks for yor assist.
jn
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699
|
Well whatever caused your control unit to fail may have caused it to fail again, but I would first check and replace the speed/motor control board and check the door lock mechanism. Those are the two likely sources of your problem.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
