Rank: Member
Groups: Registered
Joined: 4/26/2011(UTC)
Posts: 1
|
ignitor turns on but flame does not. Ignitor test out
is there a way to test the flame sensor?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Moderators
Joined: 7/14/2010(UTC)
Posts: 5,222
Was thanked: 1 time(s) in 1 post(s)
|
Originally Posted by: David schuler  ignitor turns on but flame does not. Ignitor test out
is there a way to test the flame sensor? David Yes, there is a way to test the Flame sensor, You'll need a multi meter and check across the two terminals of the sensor(with the wires off) for a closed circuit, when the sensor is cool. BUT, If your ignitor comes on, and after a few seconds it turns off, your flame sensor is OK, and based on your description, you most likely will need the solenoid coils for the gas valve. Part number: AP3094251
Good Luck, :) :) :)
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
