Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error
GE Washing Machine fills, and drains but does not Agitate/Spin
Options
Go to last post Go to first unread
Model: WBSR3140G2CC Brand: GE Age: 5 - 10 years
Previous Topic Next Topic
Where's the EASY BUTTON  
#1 Posted : Monday, May 13, 2013 5:37:42 PM(UTC)
Where's the EASY BUTTON

Rank: Member

Groups: Registered
Joined: 5/13/2013(UTC)
Posts: 4
Help will be greatly appreciated...
Back to top
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com 		 
Back to top  
Where's the EASY BUTTON  
#2 Posted : Tuesday, May 14, 2013 2:26:09 PM(UTC)
Where's the EASY BUTTON

Rank: Member

Groups: Registered
Joined: 5/13/2013(UTC)
Posts: 4
any ideas?
Back to top
Ladderdaddy  
#3 Posted : Tuesday, May 14, 2013 5:56:21 PM(UTC)
Ladderdaddy

Rank: Member

Groups: Registered
Joined: 5/14/2013(UTC)
Posts: 4
Did you check the drive belt?
Back to top
Where's the EASY BUTTON  
#4 Posted : Tuesday, May 14, 2013 8:24:16 PM(UTC)
Where's the EASY BUTTON

Rank: Member

Groups: Registered
Joined: 5/13/2013(UTC)
Posts: 4
Yes It's In Great Condition
Back to top
fairbank56  
#5 Posted : Wednesday, May 15, 2013 4:52:13 AM(UTC)
fairbank56

Rank: Advanced Member

Groups: Expert
Joined: 10/16/2012(UTC)
Posts: 3,806

Was thanked: 7 time(s) in 7 post(s)
Check the lid switch, check for error codes using the flashing LED on top right side of motor inverter board.

Eric
Back to top
Where's the EASY BUTTON  
#6 Posted : Thursday, May 16, 2013 2:56:03 PM(UTC)
Where's the EASY BUTTON

Rank: Member

Groups: Registered
Joined: 5/13/2013(UTC)
Posts: 4
Eric,

The green LED light on the motor inverter board flashes once every second.

Thanks
Back to top
fairbank56  
#7 Posted : Thursday, May 16, 2013 3:16:53 PM(UTC)
fairbank56

Rank: Advanced Member

Groups: Expert
Joined: 10/16/2012(UTC)
Posts: 3,806

Was thanked: 7 time(s) in 7 post(s)
If the lid switch checks ok, take some voltage checks on the rightmost connector on the inverter board using the following table. There should be 120vac on two wires depending on mode and speed selection. C2 pin 3 is on the left connector and is neutral. If the voltages check out ok, then you have a bad motor/inverter.

Eric

UserPostedImage
Back to top
Users browsing this topic
Guest (6)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Privacy Policy | Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET