I recieved error code F2 E6 and was told by Whirlpool to replace the the control board which I did.

After replacing that part thern I get error codes F2 E1. Which states that I have to replace the Keypad.

Is this out of the ordinary that both parts become defective at the same time? What would cause something like this? If I replace the keypad will this fix the problem or should I be looking for something else.

I would really like to order the parts so we can use the oven.

Thanks
Ed

I checked the flat cable ohmage wise and there was continuity between the diodes on the control board and the flat cable fingers.

From the fingers to the keypad I cannot check except from finger to finger but I have no idea what the ohms readings would be. Any ideas?

Nat

Did you find anything out about this?

Thanks
Ed