Rank: Member
Groups: Registered
Joined: 8/2/2010(UTC) Posts: 2
|
How do you replace the water level switch on my Whirlpool Washer.
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 7/27/2010(UTC) Posts: 1,395 Location: near the middle of nowhere Was thanked: 24 time(s) in 24 post(s)
|
Originally Posted by: gdbrr1 How do you replace the water level switch on my Whirlpool Washer. Its not too bad of a job. There are two screws located at each end of the control panel on the back side. Loosen these until the control panel can be pulled forward about half an inch. Then the control panel just rotates up and back on it own hinges. Take the knob off the pressure switch and then disconnect the wires and pressure dome tube. There should be a tab you pull back and rotate the whole pressure switch until it is free of the control panel. Reverse to reassemble. part no. AP3890868
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/2/2010(UTC) Posts: 2
|
Thank for your reply. I'll be tackeling this job when the switch comes in.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close