front load won't go into fast spin Options  Email this topic  Watch this topic  Print this topic » Normal Threaded
Model: 417.42042100	Brand: Sears	Age: 5 - 10 years
Previous Topic Next Topic

Steve Jacobsma		#1 Posted : Tuesday, July 8, 2008 4:50:41 PM(UTC)
Rank: Member Groups: Registered Joined: 7/8/2008(UTC) Posts: 3		I replaced the tub and bearings on the wash machine. Now it will only go into the fast spin cycle every once and a while. Everything else seems to work just fine.
User Profile View All Posts by User View Thanks

Sponsor
	See inside of your appliance - diagrams and part photos for virtually every model. By Model Number By Part Description By Part Number powered by AppliancePartsPros.com

richappy		#2 Posted : Wednesday, July 9, 2008 2:54:46 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Check all the connectors for a loose pin, if ok, pull out the service sheet and check the timer, soap dispenser magnet, and the door latch.
User Profile View All Posts by User View Thanks

Steve Jacobsma		#3 Posted : Thursday, July 10, 2008 5:29:18 PM(UTC)
Rank: Member Groups: Registered Joined: 7/8/2008(UTC) Posts: 3		I checked the pins and they seem ok. I tried another used door latch; no spin. I found a tech sheet but not a service sheet. Are these different?
User Profile View All Posts by User View Thanks

richappy		#4 Posted : Friday, July 11, 2008 1:38:26 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		You will need a meter to check things.
User Profile View All Posts by User View Thanks

Steve Jacobsma		#5 Posted : Friday, July 11, 2008 4:23:07 PM(UTC)
Rank: Member Groups: Registered Joined: 7/8/2008(UTC) Posts: 3		I have a multimeter but do not have a lot of experience using it.
User Profile View All Posts by User View Thanks

richappy		#6 Posted : Saturday, July 12, 2008 3:24:40 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Your data sheet should have a chain circuit to check when spin fails. Just check all the items with the ohm meter, remove power first.
User Profile View All Posts by User View Thanks

Users browsing this topic

Guest (4)