For several months the ice dispenser has made a loud buzzing noise when working. I assumed it was a solenoid problem. Yesterday, the dispenser stopped working entirely. To be safe, I'm considering ordering the following parts: control board, solenoid and dispenser switch. If I'm going to attempt to do the replacement myself, I'll need some pretty detailed instructions on how to proceed. For example, I assume I access the parts from the front but how do I get the cover off? Pretty basic, right?

The alternative is to get a new refrigerator since I imagine having this 11 year-old model repaired by a professional would cost $200 to $300.

O.K. Thanks, I got the cover off. [One of the two little prongs broke off in the process, so I'll need to know if there is a work around for that.] I removed the eight screws (but who's counting), pulled the unit out (it's a very tight fit -- it's going to fun getting it back in), and disconnected the wiring harness and the ground wire. Only the water line remains connected to it. The very top of the pad that starts water or ice flowing has scorch marks on it, so something must have shorted. The dispenser unit is encased in insulation and the compartment into which it fits is lined with styrofoam. I don't see any of the parts that I assumed in my earlier message would need to be replaced.

Help!

You need to remove the small panel that says ice water cube crush

That was a lot easier. I know you know what I'm seeing after having removed the face plate and the 4 screws but, for the benefit of others who may have this problem in the future, here's an image:

http://additionalinfo.sy..._and_Water_Dispenser.php

So, what parts should I order and how do I install them?

Thank you.