Rank: Member
Groups: Registered
Joined: 11/18/2009(UTC) Posts: 2
|
When we push the start button the dryer runs and fires only if you hold it on. It quits if you let the button up. I replaced the ignitor, flame sensor and coils. I have checked thermal fuse, and 2 thermostats. I think it has to do with the start relay but don't know how to remove or check to see if is is functioning.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 11/18/2009(UTC) Posts: 2
|
I finally got the start relay switch out. There is a bar you lift up and then twist it and it comes out. I pulled the switch apart and found that the coil wire was broken. I got a new switch relay and installed and it works like a champ
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/29/2009(UTC) Posts: 11,699
|
Yeah, it is not intuitively obvious. Thanks for the update, because this is a common problem.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close