Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
ut1031  
#1 Posted : Thursday, September 1, 2016 1:11:27 PM(UTC)
ut1031

Rank: Member

Groups: Registered
Joined: 9/1/2016(UTC)
Posts: 3

I have replaced the motor and control board and still the Clean light flashes 6 times, pauses, then 1. When I put it in diagnostic mode, it runs through the cycles, adds water, runs, pumps it out and in the end the control panel is blank. When I then select Normal wash, I do not hear it filling and then in a matter of seconds the clean light flashes 6 times then 1 signifying a communication error. Any thoughts/ideas????
thx, Kelly
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
Gene  
#2 Posted : Friday, September 2, 2016 12:31:13 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Have you called Jenn Air or Maytag for the warranty service? Your dishwasher is under one year warranty.
ut1031  
#3 Posted : Sunday, September 4, 2016 6:05:46 AM(UTC)
ut1031

Rank: Member

Groups: Registered
Joined: 9/1/2016(UTC)
Posts: 3

Bought from a freight salvage outlet......
Gene  
#4 Posted : Sunday, September 4, 2016 12:20:48 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
You may want to check the heating element and the hi-limit thermostat (#10 on the diagram) for continuity. Do not forget to unplug the dishwasher and to disconnect the wires from the heating element and hi-limit thermostat terminals prior to the continuity test.

Post the results.
ut1031  
#5 Posted : Wednesday, September 14, 2016 6:29:34 AM(UTC)
ut1031

Rank: Member

Groups: Registered
Joined: 9/1/2016(UTC)
Posts: 3

I opened it up and tested the hi-limit switch and the heating element. i am using a digital unit and set it to the lowest ohms setting. After unplugging the unit and removing the wire connections, i placed a probe on each terminal. when I first touched then i get a -1 then shortly after the number jumps between 12.0 and 18.0 on the element. The hi limit switch i get a 0.3 number. i have read the tutorial and maybe do not understand. thx, Kelly
Users browsing this topic
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.