Rank: Member
Groups: Registered
Joined: 1/28/2008(UTC) Posts: 1
|
The "clean" light and the "light wash" light keep blinking. There is water in the bottom of the dishwasher that I can't drain. I tried turning power on/off but that didn't work. Any suggestions? Mary
|
|
|
|
Rank: Member
Groups: Registered
Joined: 5/2/2008(UTC) Posts: 1
|
Originally Posted by: marycf The "clean" light and the "light wash" light keep blinking. There is water in the bottom of the dishwasher that I can't drain. I tried turning power on/off but that didn't work. Any suggestions? Mary The Maytag diagnostic tips manuals says: During Automatic Function Test, if a fault has been detected, the test will abort and 2 LED's will begin to flash. The CLEAN LED and: Keypad 2 LED ("light wash") - Motor - low current. I'd have someone check the voltage on the circuit your dishwasher is attached to make sure it is a at 120volts. Sounds like you have a brown-out voltage issue. Good Luck!
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 11/7/2007(UTC) Posts: 622
|
it appears your control board has failed
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close