Rank: Member
Groups: Registered
Joined: 9/3/2009(UTC) Posts: 1
|
When start running 15-20 second and stop. Motor runing and a heat come on, but stop after 15-20 second, this is doing every position of Cycle Selector . Can't display a diagnostic codes ehter. This dryer 3 and half years old only. This day was power outgage few times for few seconds, and a dryer was run. Can by demage a control board?
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/29/2009(UTC) Posts: 11,699
|
If you cannot get the dryer into diagnostic mode, then replacing the control board is the likely solution. Unfortunately you won't know this until you actually spend the money and do it.
Good luck, hope that solves it.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close