Rank: Member
Groups: Registered
Joined: 12/3/2007(UTC) Posts: 1
|
I set temp to 400 and oven preheats in less than a minute - after 20mins oven temp only 200 deg - is this a control panel problem?
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/3/2007(UTC) Posts: 25
|
You could check the thermostat sensor in the oven itself. It sends a message to the controls. I am not up on how to test this. But if you look for some info on posts someone may know. I believe it is either good or bad, meaning if you check it with an ohmeter, it either reads 0 or infinite or a low scale reading. Again I am not sure on the exact procedure. But it should be checked.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/3/2007(UTC) Posts: 25
|
Also check that your thermostat is correct. On a digital display it will be there somewhere, using the control pads you can set the thermostat. Read your owners manual. The thermostat may not be set correctly.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close