Rank: Member
Groups: Registered
Joined: 5/31/2008(UTC) Posts: 2
|
Washer won't fill with cold water. Hot is fine. If you switch the hoses just the opposite is true. My question is " Should I replace the water inlet valve and if so, can I use a universal one?" Thanks in advance
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 5/28/2008(UTC) Posts: 1,620
|
First I would take the hose off the valve and inspect the screen on the valve, and the screens on the hose if any for a clog.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 5/31/2008(UTC) Posts: 2
|
I did that already and water to machine was fine. I suspect either the valve is defective or there is no power to one side. I'm just not sure where to go from here
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 8/13/2008(UTC) Posts: 3,097
|
If I may throw in my 2 cents.....it sounds like the valve is out Nat
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close