Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
mfairbanks  
#1 Posted : Sunday, August 24, 2008 6:58:47 PM(UTC)
mfairbanks

Rank: Member

Groups: Registered
Joined: 8/24/2008(UTC)
Posts: 4

I am not sure if I have the correct model # since it is worn off some. This is what I think it is D110096GQ1. The serial # is FV2804163. When it starts up there is a buzzing noise after awhile it seems to go away. But this time it did not fully drain. I had to push the cancel/drain button 3 times and it finally worked.

Is my motor going bad or do I need to clean something out?
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
libertyappl  
#2 Posted : Sunday, August 24, 2008 7:02:08 PM(UTC)
libertyappl

Rank: Advanced Member

Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097

The model number posted does not pull up. But you may just have something in your pump.
Look at your model number again it should start with a DU
Nat
mfairbanks  
#3 Posted : Wednesday, August 27, 2008 2:37:44 PM(UTC)
mfairbanks

Rank: Member

Groups: Registered
Joined: 8/24/2008(UTC)
Posts: 4

I had to call Whirlpool and think I have the model # it is DU1000CGQ1. It has been washing fine but does not drain, what could it be and how can I fix it?:confused:
libertyappl  
#4 Posted : Wednesday, August 27, 2008 5:32:22 PM(UTC)
libertyappl

Rank: Advanced Member

Groups: Senior Expert
Joined: 8/13/2008(UTC)
Posts: 3,097

Could be something stuck in the pump or the pump is out. Check for an obstruction.
mfairbanks  
#5 Posted : Thursday, August 28, 2008 4:32:40 AM(UTC)
mfairbanks

Rank: Member

Groups: Registered
Joined: 8/24/2008(UTC)
Posts: 4

Do I take it apart from the inside?

Inside the garbage disposal where the drain is, I stuck my finger to see what would happen if I plugged it a little bit. It seems to have good pressure when I do that. So there must be something stuck in the hose, Just a guess?
mfairbanks  
#6 Posted : Tuesday, September 2, 2008 10:59:17 AM(UTC)
mfairbanks

Rank: Member

Groups: Registered
Joined: 8/24/2008(UTC)
Posts: 4

I found that the check valve had some stuff caught on the end of it and inside. Problem fixed!!:D
Users browsing this topic
Guest (3)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.