Rank: Member
Groups: Registered
Joined: 10/26/2017(UTC)
Posts: 1
|
Ok, so here's what's going on:
The washer won't spin or agitate. The motor control board gave me 7 flashes, indicating an open lid switch. I bypassed it with a wire nut, and it worked for one cycle. Same thing again. This time I crimped it, and it worked for one cycle. Same thing again. I verified the circuit was closed, but still had the same 7 flashes, so I replaced the motor assembly, as the tech sheet instructed. It worked for one cycle, and now the same thing again.
Anybody got any ideas? Thanks.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/13/2014(UTC) Posts: 781   Was thanked: 1 time(s) in 1 post(s)
|
Replace the lid switch as not only does it detect the lid closed but must also detect the lid being opened after each load.... or it will give you a fault code.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
