Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error
understanding
Options
Go to last post Go to first unread
Model: DBXR463GD2WW Brand: GE Age: 1 - 5 years
Previous Topic Next Topic
image252  
#1 Posted : Monday, February 9, 2009 4:37:30 PM(UTC)
image252

Rank: Member

Groups: Registered
Joined: 12/14/2008(UTC)
Posts: 16
ok dryer has absoutley no heat ,i replaced the coils the thermostats seem to be fine, the sensor gives me a reading and the ignitor works as well, though it only glows for about ten seconds than cuts off is this normal? know thee only things i have left to check are the thermo-fuse and the heating now are there any another elements i have to check for, or are these five main parts associated with the no heat to dryer
Back to top
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com 		 
Back to top  
Gene  
#2 Posted : Tuesday, February 10, 2009 5:16:24 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
If there is nothing wrong with these five parts and the gas line is open then the problem is the gas safety valve. There is no way to test it.

- The part number for the gas safety valve is AP2043480

Gene.
Back to top
image252  
#3 Posted : Tuesday, February 10, 2009 7:15:47 PM(UTC)
image252

Rank: Member

Groups: Registered
Joined: 12/14/2008(UTC)
Posts: 16
gene if the ignitor gives me a reading can it still be bad? I'm asking only cause I was told this and just wanted to verify, also the 4wire thermostat part number ap2044414 when i tested it, i put one end of the multimeter on the left element and the other end on the far right element and got a reading, but when i tested the the two middle elements i got a reading but it said it was bad am i doing something wrong or is thermostat bad
Back to top
Gene  
#4 Posted : Tuesday, February 10, 2009 7:25:40 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
I'm not sure how to test this thermostat. You have to check the wiring diagram. If the igniter continuity test shows the closed circuit then it's good.

Gene.
Back to top
Users browsing this topic
Guest (3)
Similar Topics
Understanding how an Air Diffuser works (Refrigerator & Freezer Repair)
by fs.dolphin 8/2/2015 6:35:45 AM(UTC)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Privacy Policy | Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET