Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
cojo  
#1 Posted : Wednesday, April 28, 2010 7:33:28 AM(UTC)
cojo

Rank: Member

Groups: Registered
Joined: 4/28/2010(UTC)
Posts: 3

:) my dryer switch broke and need instructions on how put in a new one. I this easy to do?
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
sidfink43  
#2 Posted : Friday, April 30, 2010 6:21:50 AM(UTC)
sidfink43

Rank: Advanced Member

Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699

You do not say which switch it is, but if you will take off the back of the console you can gain access to the switches. The switches are held in place by an "arm" with a tab that goes into a "notch". Gently lift the tab out of the notich and twist the switch and it will come out.
cojo  
#3 Posted : Friday, April 30, 2010 7:53:46 AM(UTC)
cojo

Rank: Member

Groups: Registered
Joined: 4/28/2010(UTC)
Posts: 3

It is the little black switch that makes the light go and the dryer to run. It is in the front of the my Whirlpool Ultimate Care II dryer and is activated when the door is closed. Thanks for your help on this, sincerely, appreciated one.
sidfink43  
#4 Posted : Friday, April 30, 2010 9:57:00 AM(UTC)
sidfink43

Rank: Advanced Member

Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699

Ok, that clears it up. This is an easy repair, the switch you are referring to is the door switch, this part here.

Part number: AP3132865
Part number: AP3132865


To get to it, remove the lint screen and take out the two screws under the lint screen door. Then insert a large screw driver in the gap between the top and the front near the edges and pry up. The top will flip up and give you access to the front. Two screws hold the front on, and it rests on clips. Remove the two screws, lift up on the front and disconnect the existing door switch. Two screws inside the door hold it on. Replace the switch, reverse the take apart procedures and you are done!
cojo  
#5 Posted : Friday, April 30, 2010 12:04:29 PM(UTC)
cojo

Rank: Member

Groups: Registered
Joined: 4/28/2010(UTC)
Posts: 3

Sounds like a baby can do it! I will let you know how I do when the part comes in. Again, thanks so very much for your quick response! cojo:D
Users browsing this topic
Guest (4)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.