Rank: Member
Groups: Registered
Joined: 5/29/2008(UTC)
Posts: 3
|
Which way does the spin tube thrust washer face? (AP2905330)There is a tab on it, does it face towards the transmission or drum? What purpose does it serve? Thanks, Rick
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
That's really the spindle washer, goes on the tranny shaft to cover the c clip, recessed side towards tranny.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 5/29/2008(UTC)
Posts: 3
|
I took the tranny apart, and looked around inside, nothing seems worn or broken at first glance, but it makes a ratcheting or clicking noise during the spin cycle, and the agitator turns a little during spin. If I lift up or grab the agitator the noise stops. It is easy to stop the agitator during the spin. This happens with the tranny out or in the machine with the agitator on. I also just put in a neutral drain kit that did not help. Any suggestions? Thanks, Rick
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
If you filled the tranny with oil, it probably is OK. I have seen this problem before and it really should not be a problem.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 5/29/2008(UTC)
Posts: 3
|
The tranny is filled with oil, but it is now spinning slow???
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
Either your motor is smoking, or you have a bad clutch.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
