GE Profile Dishwasher Not Draining Completely - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

GE Profile Dishwasher Not Draining Completely Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: GSD4020202BB	Brand: GE	Age: 5 - 10 years
Previous Topic Next Topic

Thomas00000		#1 Posted : Tuesday, February 23, 2010 6:18:03 AM(UTC)
Rank: Member Groups: Registered Joined: 2/23/2010(UTC) Posts: 2		Hello. I hope this post isn't redundant; I didn't see another about my model number GE GSD4020202BB. My dishwasher won't drain completely, only partially. It used to drain fine. I have checked the drain hose, the sink disposal, the lower sump and the rear sump areas. I cleared one minor blockage but the problem remains. I did notice the rear (check?) valve seems to have a flapper component on the top of the spring assembly and this flapper is quite worn. Could this be the problem? I can send a picture if it helps. Sorry if I don't have my terminology correct; I have not located a parts diagram. Thanks for any assistance you can provide. Thomas Portland, Ore.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Wednesday, February 24, 2010 4:05:49 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Here are your parts. Body parts replacement parts for General Electric GSD4020Z02BB Dishwasher \| AppliancePartsPros.com Note could not find info on the given model number. The above is for a GSD4020Z02BB (a Z instead of a 2) [COLOR="Blue"]Could this be the problem?[/COLOR] Yes it could. If the Piston & Nut (Item 564 in Section 2) does not seal during the drain cycle some of the water is directed back into the tub instead of all of it going out the drain.
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

Thomas00000		#3 Posted : Wednesday, February 24, 2010 7:50:28 AM(UTC)
Rank: Member Groups: Registered Joined: 2/23/2010(UTC) Posts: 2		Thank you! I will order that part and see how it goes. Best regards, Thomas


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (3)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close