Here is the tech sheet
http://manuals.frigidaire.com/prodinfo_pdf/Webster/134061500.pdf

It shows what the resistances should be for the different settings.
Be sure to disconnect at least one side of it when measuring it, this prevents you from reading an alternate/ parallel circuit path.
One way to double check would be to disconnect one wire from it, tape the wire up so it cannot short to any thing. Then plug it in and give it a try.

Unplug the unit, set the timer to mid-cycle timed dry.
Tape/clip your one meter lead to the L2 side of the heater.
Leave it there
Then work your way through the components till you get to L2.
If everything stays at the approximate 13 ohms of the heater then the problem is either a bad wire from the heater to L2 or the centrifugal switch on the motor is not being activated or is toast.

Have you checked that the unit is getting the correct power.
Try flipping the breaker off/on slowly a couple times, sometimes you can loose half the line without actually tripping the breaker.
If this does nothing, check the voltage at the plug
L1 to L2 should be 240 volts
L1 to Neutral and L2 to Neutral, both should be 120 volts.
If OK
Unplug the unit and check the wires at the terminal strip in the machine to make sure none are loose or burned out
If OK
Check the power at the terminal strip.
Be careful as 240 volts is lethal !!!