Rank: Member
Groups: Registered
Joined: 4/23/2008(UTC)
Posts: 2
|
Elements will not go down to low heat. Still too hot on low. Oven works fine. Local technician has replaced terminal block at incoming pigtail, and all 4 manual control switches. No change. :confused:
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 11/7/2007(UTC)
Posts: 622
|
if burners get red on high ,and then red goes when turning down ,it maybe normal for this range, unless wattage of burners is not correct , if these are original burners ,i would doubt that
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/23/2008(UTC)
Posts: 2
|
OOOkkkaaayyyy!!! How do you recognize the wattage on an existing burner? And are other wattages readily available?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 11/7/2007(UTC)
Posts: 622
|
the wattages should be engraved on burner. call whirlpool they should be able to tell you correct wattages with model#
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
