Customer Support 7 days a week

Welcome Guest! To enable all features please Login or Register.



New Topic Post Reply
Go to last post Go to first unread
#1 Posted : Friday, July 30, 2021 4:52:44 AM(UTC)

Rank: Member

Groups: Registered
Joined: 7/30/2021(UTC)
Posts: 0
United States

WED9400sw running very hot
error code f23 and f25 flash in diagnostic mode \and for short time a 72(or73) code flashed
replaced outlet thermistor and fuse.(checked old fuse and had ~12-14K ohms(similar to new one))
still flashing same codes
checked inlet thermister and sensor(lg terminal) are in continuity and small plug terminals show ~50k ohms (which I think is ok)
unsure about replacing inlet for ~$50 as it appears good, like outlet thermistor
wondering if it is the board
checked P4 3 vs p36 wires and measure ~12Kand p8-3 vs p9-1 were similar
what to do next?
See inside of your appliance - diagrams and part photos for virtually every model.

powered by
Quick Reply Show Quick Reply
Users browsing this topic
New Topic Post Reply
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.