Rank: Member
Groups: Registered
Joined: 7/17/2020(UTC) Posts: 0
|
What causes power to go to the broiler ignitor? The oven ignitor shows 120v when selected from the oven control panel but when doing the selection for broil there is no voltage to its connector. It should show the same. Correct?
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 7/27/2010(UTC) Posts: 1,395 Location: near the middle of nowhere Was thanked: 24 time(s) in 24 post(s)
|
Yes, set on broil you should get 120 volts at the igniter connector. Check the wires all the way back to the computer board.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close