I just replaced a torn seal boot without much trouble on our washer. The original leak is gone, but now there's water streaming down the front of the washer from the center of the door. Its definitely catching on the bottom lip of the new boot. There is slight play with the hinges on the door, but even lifting up doesn't garauntee a seal. I did disassemble the front of the washer again to make sure everything lined up/was square. I don't feel/see anything out if wack.

Is it possible something is still out of line? If not, should I be looking at the door or elsewhere?

Thanks!

Thanks for the response. Meant to respond sooner. My apologies.

1) Yes, mine has the drain. My placement resembles the previous install.

2) I made sure when I installed it that each of those lugs had popped in place. Felt the backside of the facing to confirm they were all sitting in their slots.

3) What I'm getting is water trickling off the base of the door. Some of it is falling onto the floor plate inside the washer, but there doesn't appear to be any water leaking from inside. The tub is dry. The drain is dry. The underside of the boot is also dry. Once I open the door, it's clear the leak is between the door and the boot. The front of the boot is wet, and the inside of the door, below where the door seals to the washer, is also wet.

Hopefully that helps. And thanks again.