AppliancePartsPros.com
»
Appliance Repair Help
»
Washer Repair
»
Samsung Top Load Washer starts to fill then stops, code nF
Rank: Member
Groups: Registered
Joined: 2/15/2017(UTC)
Posts: 2
|
Hello, Hoping someone here has some advice for me. Recently my Samsung top load washer stopped filling during most of the wash cycles. Here is what happens: [LIST=1] Power on
Fill washer with clothes/detergent
Close lid
Select wash (Normal is most frequently used)
Washer drains tub of leftover water
Washer starts to fill/spin tub at same time
About 45 seconds later washer stops filling (tub still spins)
~6 minutes later the nF code is thrown because water level hasn't changed[/LIST]Here are the things I have done so far:
- Pull/clean/replace the intake screens (no issues)
- Run through the quick tests - all seems good i think?
- Replaced the water level sensor with one from APP.com (just the sensor, not the hose itself due to time restraints)
Nothing I have done has changed anything. The washer still starts to fill and then stops. I don't think its the lid switch and here is why, if I set it to rinse/spin it will fill the entire tub (almost overfill) and it will run the entire cycle. I don't think it would run if the lid switch was bad, could be wrong?
Any help is greatly appreciated. Thanks!
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 2/15/2017(UTC)
Posts: 2
|
Bumping this, anyone have any ideas?
|
|
|
|
|
|
AppliancePartsPros.com
»
Appliance Repair Help
»
Washer Repair
»
Samsung Top Load Washer starts to fill then stops, code nF
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
