Rank: Member
Groups: Registered
Joined: 11/2/2016(UTC) Posts: 1
|
i have replaced the door boot on a Frigidaire Affinity washer. The boot is fully installed, all springs are in place. The door will not close. It is catching on the boot at the bottom. I have verified the boot is seated all the way around. Any suggestions what I should check or change?
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/13/2014(UTC) Posts: 781 Was thanked: 1 time(s) in 1 post(s)
|
I am curious, why did you have to replace the boot on such a young machine? Was it the door possibly being out of line that caused the first boot to go bad? If the door is sagging then this may be the problem.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close