kenmore he3 elite washer water temperature control - Appliance Repair Forum

Welcome Guest! You can not login or register.

Notification

Error

kenmore he3 elite washer water temperature control Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: 110.44932200	Brand: Kenmore	Age: More than 10 years
Previous Topic Next Topic

E!iteH#3		#1 Posted : Sunday, July 24, 2016 12:49:19 PM(UTC)
Rank: Member Groups: Registered Joined: 7/24/2016(UTC) Posts: 2		Okay I need help. I have a kenmore elite he3 washer that turns on both the cold and hot water solenoids when cold/cold water has been selected. Now I'm washing my clothes in hot water. I have replaced the control user interface panel as well as the circuit board assembly in the rear of the machine. I have also replaced the temperature sensor but still have the problem. Any help would be greatly appreciated. Thanks, Brad


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

brobriffin		#2 Posted : Monday, July 25, 2016 5:35:35 AM(UTC)
Rank: Member Groups: Registered Joined: 6/13/2014(UTC) Posts: 781 Was thanked: 1 time(s) in 1 post(s)		Does this happen in rinse cycle as well? Most rinse cycles are cold only. If your getting hot water in rinse as well and have replaced all the control parts, have you turned off the hot water spigot and ran a cold load to verify the cold valve is opening? If so then check the wiring to the solenoids. See if there may be a chaffed wire between the hot and cold wiring.
		WWW

User Profile View All Posts by User View Thanks

E!iteH#3		#3 Posted : Monday, July 25, 2016 1:53:41 PM(UTC)
Rank: Member Groups: Registered Joined: 7/24/2016(UTC) Posts: 2		I have verified wires are okay. I may have received defective parts - they were used. my guess is the issue is with the main control board (rear of machine). the user interface board is displaying cold/cold. is there a way to verify the serial cable is communicating the proper input to the main control board? What other than the main control board would turn on the hot water solenoid when cold has been selected?


User Profile View All Posts by User View Thanks

brobriffin		#4 Posted : Monday, July 25, 2016 3:13:17 PM(UTC)
Rank: Member Groups: Registered Joined: 6/13/2014(UTC) Posts: 781 Was thanked: 1 time(s) in 1 post(s)		Its pretty basic that control board operates everything. So if you turn off the hot water it still fills with cold? If so then I suspect control board. I only buy new or certified rebuilt myself.
		WWW

User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close