Customer Support 7 days a week

Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

New Topic Post Reply
Options
Go to last post Go to first unread
retho78  
#1 Posted : Saturday, May 21, 2016 5:29:56 AM(UTC)
Quote
retho78

Rank: Member

Groups: Registered
Joined: 3/30/2010(UTC)
Posts: 4

I have a maytag washer that does not spin or go through the cycle and drain properly so after reading all over the internet I replaced the shift actuator (twice) and it didn't make any difference. I also swapped out the capacitor just to be sure but nothing. I ran it through the diagnostic mode and it flashes the sensing light and the sensing, spin, rinse and done. After replacing the above mentioned parts I did a calibration test it ran for few seconds with water fill then sense and stops and the lid light flashes for a while and turns off.


Any idea what could be the problem, main board, lid switch?
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
retho78  
#2 Posted : Saturday, May 21, 2016 11:19:36 AM(UTC)
Quote
retho78

Rank: Member

Groups: Registered
Joined: 3/30/2010(UTC)
Posts: 4

Anyone that might know what could be the problem?
Quick Reply Show Quick Reply
Users browsing this topic
New Topic Post Reply
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.