Rank: Member
Groups: Registered
Joined: 2/25/2016(UTC)
Posts: 4
|
I have been trying to repair a GE dryer that at first wouldn't run. Power came on but timer counted down in seconds. I have replaced the Power board and now it runs but doesn't heat. I have tested the Hight Temperature Thermostat and have continuity. I do NOT have continuity on the Inlet Safety Thermistor. I have jumped the Inlet Saftey to bypass by still get no heat. Also is there any specific order the Red and Orange wires connect to the High-Temperature Thermostat as I faild to look before I removed them for testing. I also have continuity on the Heating coil and all other sensors. The only one that seems not to register is the Inlet Safety on.
.......HELP HELP HELP PLEASE:eek: .......
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 2/25/2016(UTC)
Posts: 4
|
Is this something no-one has had issues with before? Strange I get no replies...
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
