Rank: Member
Groups: Registered
Joined: 2/18/2016(UTC)
Posts: 1
|
Received new mounting stem repairing kit. Inserted it and now it is stuck. Not sure if I hit it when placing inner tub. When I placed inner tub, stem is too high and inner tub won't sit correctly. Unable to remove new mounting stem. I removed screw. Unable to move stem. Any suggestions helpful.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Moderators
Joined: 7/14/2010(UTC)
Posts: 5,222
Was thanked: 1 time(s) in 1 post(s)
|
Originally Posted by: gtweed  Received new mounting stem repairing kit. Inserted it and now it is stuck. Not sure if I hit it when placing inner tub. When I placed inner tub, stem is too high and inner tub won't sit correctly. Unable to remove new mounting stem. I removed screw. Unable to move stem. Any suggestions helpful. gtweed, Sounds like you may have cross threaded the top of the transmission casing ? Hitting or banging a mounting stem kit wouldn't usually create a problem like your'e describing. There's been times where the original mounting stem had to be chiseled or cut off, but installation of a new stem kit wasn't loke you described. Recheck and make sure you didn't miss a step.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
