Rank: Member
Groups: Registered
Joined: 10/29/2009(UTC) Posts: 2
|
I just installed the High Torque Tranny. The support springs do not support equally. The springs attached using the Hooks are loose. Is the new tranny a different height? What can I do to correct this prob.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Check the proper installation of the transmission supports. Check the Service manual (pages 24 & 25). Gene.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/29/2009(UTC) Posts: 2
|
Originally Posted by: Gene Check the proper installation of the transmission supports. Check the Service manual (pages 24 & 25). Gene. Thanks Gene! Especially for the Service Manual! I have the machine working properly, but the springs are too loose (only the three attached to the upper support). I believe that the top support "floats" and can be adjusted upwards without having to disassemble can you verify?:rolleyes:
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close