Rank: Member
Groups: Registered
Joined: 1/18/2015(UTC)
Posts: 3
|
My family has noticed that the dishwasher has been making our dishes dirtier than what they were before putting them in. The soap dispenser will not open, and I can't figure out why. The Control board, 4 prong connector had melted, so I installed a new board, spliced in new connectors. That is when the soap disp. stopped opening. I even installed a new soap disp. it's still not opening. so I checked the heater it's OK, checked water level it's Ok. Found 3 prong connector loose, spliced in new connectors now it's OK. Checked all wiring it's Ok, and electric is going to soap disp. I am lost as to what it could be, do I have to give up and just buy a new dishwasher? :confused:
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 1/18/2015(UTC)
Posts: 3
|
Here is an update. Long story short the new control board I bought from Sundberg America was bad. After buying a new control board the dishwasher now works great. Sundberg America will not replace the defective part they sold me.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
