Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
scottfross  
#1 Posted : Sunday, November 30, 2014 7:20:40 AM(UTC)
scottfross

Rank: Member

Groups: Registered
Joined: 11/30/2014(UTC)
Posts: 2

Wiring MGDC300XW1.pdf (603kb) downloaded 7 time(s).
Is this melted black stuff on the pulley from the belt that melted or the pulley itself melting? and can i replace just the pulley instead of the whole motor. All the parts lists I'm seeing only has the entire motor for replacement not just the pulley.
Thank you
scottfross attached the following image(s):
FullSizeRender-1.jpg
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
sidfink43  
#2 Posted : Monday, December 1, 2014 3:04:50 PM(UTC)
sidfink43

Rank: Advanced Member

Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699

That is just the pulley, they regularly do that on these models and yes you should be able to just replace it. You are right, I don't see it separate from the motor but call APP because they should be able to sell you just the pulley.
scottfross  
#3 Posted : Monday, December 1, 2014 6:13:24 PM(UTC)
scottfross

Rank: Member

Groups: Registered
Joined: 11/30/2014(UTC)
Posts: 2

ok, i managed to get the pulley clean of all the melted stuff and bought a new belt but it seems like the belt is loose and when running a wash cycle the tub doesn't spin fast enough to get the water out. Is there a way to adjust the tension on the belt?
sidfink43  
#4 Posted : Tuesday, December 2, 2014 3:49:31 AM(UTC)
sidfink43

Rank: Advanced Member

Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699

On this model the motor pivots to act as a clutch, so the belt should be loose when it is not operating.

The most common problem with lack of adequate spin on this machine is the thrust bearing, this part here

Part number: AP4009132
Part number: AP4009132


Try changing it out and then observe the machine running with the front panel off to see if there is a problem with the motor pivot.
Users browsing this topic
Guest (3)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.