Rank: Member
Groups: Registered
Joined: 1/16/2014(UTC) Posts: 2
|
Dryer will not start..push button makes a clicking noise from main board.. Door switch is functioning properly. Thermal fuse is good. Pulled P1 connector off board and read 2 ohms on motor circuit. Is it likely the board is bad?
|
|
|
|
Rank: Advanced Member
Groups: Expert
Joined: 10/16/2012(UTC) Posts: 3,806
Was thanked: 7 time(s) in 7 post(s)
|
Missing last three characters of model number. P1 is not the motor circuit.
Eric
|
|
|
|
Rank: Member
Groups: Registered
Joined: 1/16/2014(UTC) Posts: 2
|
Was actually pin 3 and 4 light blue and blue wire.. Said it was motor circuit and supposed to read 1to 6 ohm.couldn't remember last digits of model, get it when I get home
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close