dryer current draw - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

dryer current draw Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: WED4900XWO	Brand: Whirlpool	Age: Less than 1 year
Previous Topic Next Topic

All Wet		#1 Posted : Sunday, December 22, 2013 8:55:00 AM(UTC)
Rank: Member Groups: Registered Joined: 1/3/2010(UTC) Posts: 20		Bought this 12-16, 2013. 1 /2 weeks ago. Hooked up new dryer and it melted the main outside on the pole. Replaced the main (100 amp service) $45.00, and then popped the new breaker. Replaced the dryer plug on the wall, it was old anyway but it worked 2 days before it popped the main again. Do the new dryers draw more current than older ones? My house was built in 1968 and has most of the wiring done in 8 ga wire.


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

denman		#2 Posted : Monday, December 23, 2013 12:19:37 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 2/29/2008(UTC) Posts: 19,638 Thanks: 1 times Was thanked: 11 time(s) in 11 post(s)		Here are your parts Parts for Whirlpool WED4900XW0 Dryer - AppliancePartsPros.com Here is the install sheet for this unit. http://www.whirlpool.com/digita...ions%20-%20W10096987.pdf It calls for a 30 amp double pole (240 volt) circuit. See the attachment for the tech sheet. 8 gauge wire should be able to handle a 45 amp circuit. A 30 amp circuit is normally 10 gauge wire. I am not sure what is going on here. If the dryer was pulling too much current it should have popped the dryer's circuit breaker not the mains breaker. Might be best to get an electrician in. File Attachment(s): WED4900.pdf (96kb) downloaded 5 time(s).
		THIS FORUM IS DEAD!!!!!!!


User Profile View All Posts by User View Thanks

All Wet		#3 Posted : Monday, December 23, 2013 11:40:41 AM(UTC)
Rank: Member Groups: Registered Joined: 1/3/2010(UTC) Posts: 20		That sounds like the next srep. Seems it should trip the dryer circuit first and not the main. I'm thinking the connection at pole to house needs investigating. Thank you for responding and I hope you and yours have a very Merry Christmas. Bill


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close