Rank: Member
Groups: Registered
Joined: 9/11/2013(UTC)
Posts: 5
|
had low flame on all burners and in oven , checked supply it was good and replace the supply valve and still no change. I cleaned all orifices and am now at a loss as to what could be causing it.
Any suggestions?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/16/2013(UTC)
Posts: 916
|
Sounds like you have a bad regulator or low gas pressure going to unit....
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 9/11/2013(UTC)
Posts: 5
|
Originally Posted by: HumboldtRepairMan  Sounds like you have a bad regulator or low gas pressure going to unit.... Gas company checked pressure at supply line and it was good, I replaced the Pressure valve PART NUMBER: WB19K28 and no change. Not sure, but i believe that is the pressure regulator valvle I replaced. Thanks though any other thoughts?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/16/2013(UTC)
Posts: 916
|
have you recently changed this unit from propane or to propane at all?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 9/11/2013(UTC)
Posts: 5
|
Originally Posted by: HumboldtRepairMan have you recently changed this unit from propane or to propane at all? Sorry did not mention that it is propane and has been since new
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 7/16/2013(UTC)
Posts: 916
|
And you have the new regulator put in the LP position? There should be a switch somewhere on it......also did you change the orfice out of the regulator and put the LP orfice in the new regulator you installed?
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 9/11/2013(UTC)
Posts: 5
|
Originally Posted by: HumboldtRepairMan And you have the new regulator put in the LP position? There should be a switch somewhere on it......also did you change the orfice out of the regulator and put the LP orfice in the new regulator you installed? Didn't think about that, is it the brass plug/nut on the side of the regulator? I changed the orifice to LP and no change. I could not find a switch, but the stove worked fine until a few weeks ago. I even changed the safety valve today just to be sure. and replaced the supply line to. It lights just fine then the flame goes very small. This is the case on all four burner and the oven.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
