Need to check Emitter for Ice Maker - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! You can not login or register.

Notification

Error

Need to check Emitter for Ice Maker Options Email this topic Watch this topic Print this topic » Normal Threaded
Model: GSF26C5EXY00	Brand: Kenmore	Age: 1 - 5 years
Previous Topic Next Topic

demetros		#1 Posted : Thursday, June 6, 2013 5:14:57 AM(UTC)
Rank: Member Groups: Registered Joined: 6/6/2013(UTC) Posts: 2		I received part # W10180607 from Appliance Parts which is a circuit board emitter for an ice maker. I put the part in last night but the ice maker is not working. I may need to purchase the corresponding receiver circuit board. Before I do that is there a way I can check to see if the emitter that was sent is truly working?


User Profile View All Posts by User View Thanks

Sponsor

See inside of your appliance - diagrams and part photos for virtually every model.

richappy		#2 Posted : Friday, June 7, 2013 12:45:18 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Close the flapper on the left side and push in the light switch. Take a picture of the beam with a cell phone or camera. Should show the infra red beam.


User Profile View All Posts by User View Thanks

demetros		#3 Posted : Friday, June 7, 2013 4:43:09 AM(UTC)
Rank: Member Groups: Registered Joined: 6/6/2013(UTC) Posts: 2		Thanks Rich. Looks like emitter is working. If I unplug the fridge for 5 seconds and then plug it in again then I see a steady red light on the LED at the receiver. A short time later I hear the ice maker motor come on for a short time. Within minutes the LED stays off and I can't make it come back on unless I unplug the fridge again. And no ice made. Should I try testing the ice maker?


User Profile View All Posts by User View Thanks

richappy		#4 Posted : Saturday, June 8, 2013 7:14:37 AM(UTC)
Rank: Advanced Member Groups: Senior Expert Joined: 9/10/2007(UTC) Posts: 9,586 Was thanked: 2 time(s) in 2 post(s)		Remove the receiver board, the one with the relay and put a thin, wire jumper between the black/ white and black connector pins temporarily. Icemaker should now get 115 volts, if not, you have a bad wire in the fridg.


User Profile View All Posts by User View Thanks

Aunueget		#5 Posted : Tuesday, June 21, 2016 9:15:48 AM(UTC)
Rank: Member Groups: Registered Joined: 6/21/2016(UTC) Posts: 1		I'm having the same problem where if i unplug and plug back in the red light will be on steady but after a few minutes it goes out. Did you find a solution?


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest (5)

Forum Jump

You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close