Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error

Options
Go to last post Go to first unread
jcarlson51  
#1 Posted : Friday, October 2, 2009 5:35:07 PM(UTC)
jcarlson51

Rank: Member

Groups: Registered
Joined: 10/2/2009(UTC)
Posts: 3

Ok where to start. My dryer start squeaking a few weeks back so i did what one post said do and replaced the Assembly - shaft (ballhitch). got the dryer all back together the squeaking is gone but now there is no Heat coming form the dryer. Need some help trying figure out what wrong with it now.:confused::(
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
wally412  
#2 Posted : Friday, October 2, 2009 7:10:59 PM(UTC)
wally412

Rank: Member

Groups: Registered
Joined: 10/2/2009(UTC)
Posts: 4

dryers run on 220 if one side of the 220 is blown it will run but not heat or also you could have a bad heating element or broken wire to the element but im no expert a just had one do that to me in my case it was a blown fuse on one side of the 220 i hope this helps but remember i dont clam to be an exepert wally 412 perry iowa the hawkeye state
jcarlson51  
#3 Posted : Friday, October 2, 2009 7:13:48 PM(UTC)
jcarlson51

Rank: Member

Groups: Registered
Joined: 10/2/2009(UTC)
Posts: 3

What fuse are you taking about on the dryer its self.
wally412  
#4 Posted : Friday, October 2, 2009 7:17:53 PM(UTC)
wally412

Rank: Member

Groups: Registered
Joined: 10/2/2009(UTC)
Posts: 4

were the 220 is suplyed to the dryer
jcarlson51  
#5 Posted : Friday, October 2, 2009 8:14:54 PM(UTC)
jcarlson51

Rank: Member

Groups: Registered
Joined: 10/2/2009(UTC)
Posts: 3

Got ya. All ready check that and it all good im getting 220 at the wall plug. But still no heat.....
SublimeMasterJW  
#6 Posted : Saturday, October 3, 2009 2:56:13 AM(UTC)
SublimeMasterJW

Rank: Advanced Member

Groups: Senior Expert
Joined: 5/6/2008(UTC)
Posts: 724

Was thanked: 1 time(s) in 1 post(s)
Go back in there and check the heater element for a break. Maybe you left a wire off when you did the repairs. At any rate: You can get a restring kit for about $25. Just remember to evenly space the new wire so it will not burn out quickly. Remove all lint from the dryer and the drum. This is the main killer of a heater element. Lint on it causes a hot spot.

UserPostedImage


5300622032 Restring kit $25


The fuse mounts on the rear wall of the dryer in the upper right hand corner. If it blows the dryer will not run. Clean out the vent and any lint in the dryer or the fuse will continue to blow.

UserPostedImage

134120900 Fuse $12
Users browsing this topic
Guest (4)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.