My waher comes to the end of the cycle and the clothes are still dripping wet. I ran it back through the spin cycle and found that the tub wasn't spinning. I took out all of the clothes and tried it again and sometimes it spun, other times it didn't. When I added clothes back into it while it was spinning, it slowed down as the weight got heavier. I was able to start the tub turning with my hand and it would engage and start to spin on it's own, although not very fast. I originally thought a slipping belt, until I looked and found that it didn't use a belt. From videos that I have watched, it seems to be acting like a slipping clutch, but I'm not sure. Can you help me?

Well I replaced the clutch assembly and everything worked great for the first few loads. Unfortunately the problem came back. I think it may be related to weight, as the first few loads were smaller and used less water. Again though, the bin just needed some help to get started. I pushed it into motion and it continued to spin on it's own and soon it got up to speed. Any suggestions on what this could be?