Rank: Member
Groups: Registered
Joined: 8/14/2009(UTC)
Posts: 1
|
controls are locked, can anyone advise a solution?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 3/29/2009(UTC)
Posts: 11,699
|
If you have not already tried these, 1. Unplug the machine to see if the controls will free up 2. Check the drain system for any blockage or problems. If you can get the machine into diagnostic mode you may be able to determine the problem. Here is the tech sheet. http://www.servicematters.com/m...library/docs/8182208.pdfIf you cannot get the machine into test mode, a new control board is likely needed, but if you replace it you are doing it on speculation since that cannot be confirmed as the problem. Wish I could be more definitive. Good luck.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 4/28/2013(UTC)
Posts: 1
|
"On certain Maytag models equipped with an electrical panel, the "controls locked" status light may be lit. If so, press and hold the cycle signal button for three seconds. This will turn off the controls locked feature, resetting the dryer for use."
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
