Took delivery of new dishwasher yesterday, installed it today. Once all hooked up, I closed the door, and the machine automatically started (set on auto wash). No leaks in my plumbing :) , so I cancelled the program as per manual (hold down cancel and reset buttons for a few seconds), and machine drained. A little later we loaded and tried to run a quick wash, but the control panel wouldn't respond to anything - there was a 0 on the display and the Auto wash button was lit, and we couldn't change this. In the end turning off the machine and holding down right cancel/reset button and then holding down power button for a few seconds (the method for changing cycle completion signal) was how I cleared this - I was then able to select any program. I set it for quick wash, and the program ran. Now, we have the same issue. 0 on the screen, and the Quick Wash button light is on. I can't get anything to change, and machine doesn't run quick wash if door closed. I have tried the combinations of buttons to cancel a program and for the various functions in the manual, nothing, as well as a few other combinations. Turned off breaker for 45 minutes, nothing.
Is this a dud right out of the box, or am I missing something? I'm hoping I am missing something, but don't think I am. Great introduction to Bosch. What a day.:mad:. Now going to get a cold beer...
Thanks for any insight,
Kodge.