Rank: Member
Groups: Registered
Joined: 1/18/2012(UTC) Posts: 2
|
My refrigerator is stuck at 58 degrees. We just replaced the main board as the temperature contol settings were not lighting up and it would not cool at all. The compressor is kicking on and off and it is set at the factory settings of 0 and 38. Any ideas of what the problem could be now?
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC) Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
Remove the motherboard cover and locate the 3 pin power connector. Remove the connector and put a jumper wire between the connector mating pins as labled on the motherboard line and comp. Plug in refrigerator. If the compressor still kicks out, you might have a bad start device, rather rare for GE, but possible.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 1/18/2012(UTC) Posts: 2
|
Thanks for the help compressor is shot...story of my life
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC) Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
How do you know the compressor is bad?
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close