Rank: Member
Groups: Registered
Joined: 12/30/2007(UTC)
Posts: 2
|
My Maytag top loader was leaking, I diagnosed bad tub seal, got the correct part & spanner wrench, r&r the old seal, on reassembly I can't seem to get tub installed properly, have done several loads, no leak, but vibration/contact tub seems to not be aligned, installed incorrectly? any advice?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
Make sure each tub support spring is the same length as before. Also, check the feet to make sure they are all touching the floor.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/30/2007(UTC)
Posts: 2
|
springs were not touched,spanner nut rests directly on tub, which is hard to center, I can see it turn unevenly, the new seal was updated,as far as I know I reassembled correct, does anyone have a parts schematic?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC)
Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
You need to loosen the tub nut and re-adjust tub to center it.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
