Rank: Member
Groups: Registered
Joined: 12/13/2007(UTC)
Posts: 2
|
How do you take apart panel to put new one in?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Open the lower oven door and remove the screw on each side of the side trim. Pull the bottom of the side trim toward yourself and down to release it from the control panel tab. Remove the screw on each side of the control panel. Pull the bottom of the control panel toward yourself and up to release the upper tabs. - Here are the break down diagrams for the Whirlpool oven Model RBD305PDB13Gene.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/13/2007(UTC)
Posts: 2
|
Great that worked.
I was getting F2 E6 error replaced touch key and checked ribbon cable its ok but still not fixed I am replacing computer control board next. Any thoughts ? This is what the paper documentation from whirpool says to do that I found in top of oven.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Yes, if you already replaced the key pad and it did not help, per the Whirlpool technical sheets, the control board has to be replaced either.
Gene.
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
