Customer Support 7 days a week

Welcome Guest! You can not login or register.

Notification

Icon
Error
Removing the spin shaft flange
Options
Go to last post Go to first unread
Model: PAV2200AWW Brand: Maytag Age: 1 - 5 years
Previous Topic Next Topic
J1m  
#1 Posted : Thursday, April 30, 2009 6:23:18 AM(UTC)
J1m

Rank: Member

Groups: Registered
Joined: 4/30/2009(UTC)
Posts: 3
I am working on a Maytag Washing Machine that makes a loud roaring sound when it goes into the spin cycle-so loud you don't want to be in the same room with it.

I have removed the wash tub and the plastic nut on the spin cycle shaft but below the nut is a 4 bolt flange that I need to remove. It is aluminum and I have been to the web site and the on line help but can not tell if it is threaded or or if I need to use a puller on it.

Thanks
J
Back to top
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com 		 
Back to top  
Gene  
#2 Posted : Thursday, April 30, 2009 2:46:25 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
Hopefully the Service manual will help. Possible you'll need some special tools.

Here are the breakdown diagrams and Replacement parts for MAYTAG PAV2200AWW | AppliancePartsPros.com

Gene.
P.S. Check how freely the pump pulley is moving. It can be noisy too.
Back to top
J1m  
#3 Posted : Sunday, May 3, 2009 7:59:30 AM(UTC)
J1m

Rank: Member

Groups: Registered
Joined: 4/30/2009(UTC)
Posts: 3
Hi Gene-thanks for the link to the repair manual--that is just the bit of info I needed.
J
Back to top
J1m  
#4 Posted : Monday, May 4, 2009 9:19:40 AM(UTC)
J1m

Rank: Member

Groups: Registered
Joined: 4/30/2009(UTC)
Posts: 3
As it turns out-the spin hub is threaded and the hub may require a bit of coaxing with a rubber mallet and a large wrench. I also had to clamp the agitator shaft to keep it from turning while I rapped on the hub wrench.

Once I had it unscrewed and the tub removed I found that the hub seal had deteriorated and water had rusted the spin bearing--lots of noise. A new part from this site and all fixed.
Thanks for the help Gene.
Back to top
Gene  
#5 Posted : Monday, May 4, 2009 9:06:48 PM(UTC)
Gene

Rank: Advanced Member

Groups: Senior Expert, Administrators
Joined: 7/19/2007(UTC)
Posts: 27,455

Was thanked: 4 time(s) in 4 post(s)
You are welcome. I'm glad you were able to fix it.

Gene.
Back to top
Users browsing this topic
Guest (4)
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Privacy Policy | Powered by YAF.NET | YAF.NET © 2003-2025, Yet Another Forum.NET